We’ll allow access to the FTP server only to the local users. Start by opening the vsftpd configuration file: sudo nano /etc/nf 1. In the following sections, we will go over some important settings needed to configure a secure vsftpd installation. For all available options, visit the vsftpd documentation Most of the server settings are well documented inside the file. The vsftpd server configuration is stored in the /etc/nf file. Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: active (running) since Tue 15:17:22 UTC 3s ago The output should show that the vsftpd service is active and running: To verify it, print the service status: sudo systemctl status vsftpd The ftp service will automatically start once the installation process is complete. To install it, execute the following commands: sudo apt update sudo apt install vsftpd The vsftpd package is available in the Ubuntu repositories. We will also show you how to configure the server to restrict users to their home directory and encrypt the entire transmission with SSL/TLS.Īlthough FTP is a very popular protocol, for more secure and faster data transfers, you should use SCP We’ll be installing vsftpd (Very Secure Ftp Daemon), a stable, secure, and fast FTP server. The most known and widely used are PureFTPd There are several open-source FTP servers available for Linux. Your FTP service is now up and ready to use.This article describes how to install and configure an FTP server on Ubuntu 20.04 that you use to share files between your devices.įTP (File Transfer Protocol) is a standard network protocol used to transfer files to and from a remote network. Use the credentials created in step 5 to access the FTP service. The default directory will the home of the user, which in this case is /home/aloka ftp -p You can connect to your FTP server using the command with your public IP address. Restart FTP service so that the new configuration is activated sudo service vsftpd start sudo adduser alokaĬreate the user file list and the new user echo "aloka" | sudo tee -a /etc/erlist We will call the user aloka for now, when prompted add a password and you can just press enter for the other prompts, letting the defaults continue. We will now create a user and prepare the directory for access. Userlist_deny=NO Step 5: Add user and setup directory
0 Comments
Leave a Reply. |